for HV we've been using SQUET channels modified to reduce the shunt resistances. We have a set that works for 1-sided readout, but there are bad channels on those SQUETs

We'd like to try reading out all 12 channels on this detector - so we'd want three SQUETs with all four channels working, and presumably reduced shunts

We have three SQUETs with all good channels that we use for iZIPs - with no modifications

Probably reduced shunts would be good for iZIP too. The original 20 mΩ was meant for mZIPs, with 10× higher normal resistances than any phonon channel we have now

Starting wirebonding now, intend to have 12 good channels with reduced shunts.

Assemble and test HV board

Wire warm cable for Goldman thermometer

Wire diverter board for Goldman thermometer. Can we use the source mover board?

Check CDMSbats channel maps