Run Setup
The below setup is the same wiring as Run 83. This is done after we install the manual GHS. Run 83 has change in wiring from Run 76, 77, 78 and 79. Non-working channels: link Cable 2 SQUID A, Cable 1 SQUID C&D, Cable 3 SQUID C Notes:
- We have to swap stripline cables to find an ideal combination without short to chassis.
- We finally settled with the following configuration as shown in the table.
^ Run 84 Channel Map ^^^^^^
| Prev Det TwistedPair Conn refer | New Det TwistedPair Conn | Tower | Cable | DCRC(2sided) | Label | SQUID Bias, Offset | HV output, Side2-readout |
|---|---|---|---|---|---|---|---|
| DIB1Q (Side1pE) | DIB1Q (Side1pE) | Face5pA | Cable 2 (includes LEDs and accessories) HV CONN1 Stripline 41 ZC-70 | — | - | ||
| DIB1pB (Side1pB) | DIB3pA (Side1pF) | Face5pB | - | ||||
| DIB1pA (Side1pD) | DIB4pC (Side1pA) | Face5pC | - | ||||
| DIB1pC (Side2pE) | | Face5pD | HV2pD | ||||
| DIB3pC (Side2pC) | DIB3pC (Side2pC) | Face3pA | Cable 1 HV CONN2 Stripline 48 ZC-26 | — | SQUID Bias= -58.1 uA, Lockpoint=-3.44 mV | HV2pA | |
| DIB3pB (Side2pF) | DIB3pB (Side2pF) | Face3pB | HV2pB | ||||
| DIB3Q (Side1pC) | DIB3Q (Side1pC) | Face3pC | - | - | |||
| DIB3pA (Side1pF) | DIB1pA (Side1pD) | Face3pD | - | - | |||
| DIB3pD (Side2pB) | | Face2pA | Cable 3 HV CONN3 Stripline 4 ZC-13 | — | SQUID Bias= -89.0 uA, Lockpoint=-5.42 mV | HV1pA | |
| DIB4pD (Side2pA) | DIB4pD (Side2pA) | Face2pB | HV1pB | ||||
| DIB4pC (Side1pA) | DIB1pB (Side1pB) | Face2pC | - | - | |||
| DIB1pD (Side2pD) | DIB1pD (Side2pD) | Face2pD | HV1pD | ||||