2023/04/11 (Tuesday)
* Lab in-personnel: Himangshu
| 1140 | 1D source mover test |
|---|---|
| 1210 | Undo the source holder from last run to attach it to the 1D source holder. The source has more height than this source holder, how to let it in place? |
| 1220 | Connected the 4 wires of the 1D source mover motor coils to a breadboard using millmax pins(since the attached pins has a different pitch than the breadboard). Coil1 measures 7.45 kohm and Coil2 7.40 kohm at the breadboard |
| 1235 | Blue wire endstop 5.689 kohm and white blue wire endstop 22.45 kohm |
| 1239 | Measure resistances at the warm-side diverter board. Coil1 measures 7.59 kohm and Coil2 7.55 kohm at the warm-side diverter board |
| 1253 | At warm end diverter board, Blue wire endstop 5.75 kohm and white blue wire endstop 22.48 kohm |
| 1300 | Check that turning the potentiometer changes the overall resistances of the two coils. Anti-clockwise increase the resistance and vice-versa. |
| 1400 | Plug power in from GWiNSTEK supply and set to 7.1 V, light on red board comes on. Plug usb from fridge computer into arduino. Doubleclick Arduino_Create_Bridge_shortcut on desktop and open arduino web editor page. Used “sign in with google” and I guess it used my account, we're in. On Monitor tab type Help to remind myself of the commands. |
| 1420 | No movement. Now I see an error on the arduino.cc website stating that board and arduino is disconnected. It keeps fluctuating between connected and not connected. undo all wires and retried, same case. |
| 1450 | Worked on the twisted pair cables to make the connections as per the changed channel mapping |