| Status | Run 74 prep. 1K Pot pumped out and isolated. Fridge and 4He and LN2 Trap 1 isolated, not pumped out. Cryostat vacuum jacket pumped out. IVC open, tower removed. |
| 1010 | Matt enters lab |
| | One source mover motor coil had most of its inner end break off yesterday, so need to rewind it. |
| 1015 | Continue to unwind coil.
 |
| 1055 | Finish unwinding coil
 |
| 1105 | To start rewinding, first wind 9 rotations of wire around the 1/2-inch diameter winding shaft. That's 35.9 cm of the inner end free.
 |
| 1110 | Tape wire down into spool to start winding. Use drill to finish winding.
 |
| 1125 | Tape top end of wire onto spool. Unwind the 35.9 cm of inner end from the shaft, then wind that onto spool and tape it down.
 |
| 1140 | Scrape insulation off a few cm of the bottom end.
 |
| 1145 | Measure resistance of coil: 7.42 kΩ
 |
| 1150 | Matt leaves lab |