| Teleconference link: | https://umn.zoom.us/j/2461438631 |
| Domestic: | 1-646-558-8656 (US toll) |
| Domestic: | 1-408-638-0968 (US toll) |
| Access code: | 908-227-5310 |
- Lab Update - Run 77 preparation
- Source Mover bench test Slides/Pics
- When trying to re-compile Detector Control GUI, got error about disk quota exceeded. Contacted Chad about this and he resolved it this morning. Recompiled the mentioned GUI (still needs to test SQUIDtuningGUI again)
- Zach solder two pins together using solder wire in the Rox thermometer wires to make the 4 pin reading setup as discussed last time. Plan is to take readings at the cold side end(and not on the warm side) Picture
- Located Am241 source in safe and tried to install one on the 1D source mover radioactive source stage. Possible to install, but misalignment of collimator during installation of the tower is a concern. pictures
- Priority Updates
- General Updates
- Himangshu
- Shubham
- Jack
- Derek
- Zach
- Scott
- Giulia
- Fun Update