The Y-arm pins are finally solder as before. tried other pins available in the lab, but they break off pretty easily.
-
Zach suggested that we should try the source mover steps through the stripline assembly as there might be any possible wire reroutes that can cause no-motor coil movements. Setup the source mover next to tower to record its movement while still connected to the stripline assembly.
-
Plan is to record the steps and close the IVC today. Timeline: LN2 transfer on Monday.
Another source mover change: Keep the X-arm at the Xendstop location during cooldown and move it away from it to record that the arm is actually moving with the settings at the PC.
