Tower assembly is complete. Had a few issues with 1D source mover holder, but discussion with Matt and Zach cleared it this morning.

Used copper tape to close all screw holes on the detector and source mover housing. this was one item we decided during last run.

Pictures from the Tower assembly

1K pot pumped out (today) after the needle valve re-assembly. Matt suggested that this will help to little bit quicken the pumpout of the 1K pot during cooldown.

Need to change CDMSBats config files with the new channel map during this run. Anthony can help?

Zach will start the cryocleaning from today( onwards). Expecting to be at base early next week.

Himangshu

Shubham

Jack

Derek

Scott

Giulia