| Teleconference link: | https://umn.zoom.us/my/fritts |
| Domestic: | 1-646-558-8656 (US toll) |
| Domestic: | 1-408-638-0968 (US toll) |
| Access code: | 908-227-5310 |
- Lab Update
- Connected Side1-readout HV board. Took 20V data - looks good.
- empirical NTL gain = 7.1, a little higher than expected 6.3
- noised width reduced from ~130 eV to ~ 22 eV
- Set up remote-control HV, took 100V data
- Couldn't get power relay setup to work (this is a failsafe to turn off the HV supply if the DCRC control voltage disappears). Not sure this is necessary.
- Priority Updates
- General Updates
- Himangshu
- Implementing changes to initial fridge diagram
- Run 71 partition and delay plots for suggestions
- Shubham
- Working on Geant4 k100sim simulation.
- Played with the detectorConstrction.cc file on my local machine to understand the detector geometry.
- Side view:
- Top view:
- Bottom view:
- Github repo to evolving code: https://github.com/spandeyehep/k100sim
- Adding sensitive detectors to the geometry.
- Failed attempts to make Geant4 visualization work on cdms2 machine: Chad is suggesting to use a Docker or singularity container image file which makes it platform independent. Any suggestions?
- Jack
- Derek
- Zach
- Michael
- Scott - https://zzz.physics.umn.edu/!cdms/_media/cdms/2d_source_mover_update_2-3-22.pdf
- Giulia
- Giovanna
- Pramod
- Fun Update